What should pay attention to in the processing of coating machine ?

- Jan 29, 2018 -

Coating machine operator must accept pre-job training and after passing the examination before they can be certified, should strictly abide by the rules;Machine in the operation, except for the necessary maintenance personnel, non-staff are not allowed to operate the equipment or change the setting parameters; roller speed ratio is recommended to set in the range of 1.3 to 1.5.

 

Coating machine at the time of operation, be sure to confirm that the drying fan has been started before you can start the air heater;

The next step is to pay attention to the need to adjust the gap between the coating roller and back roller,Should be coated roller just above the wipe the slurry does not get stuck in the back roller principle,Make sure that the two rollers are parallel or have the same clearance (there must be clearance).

 

After re-setting the parameters of the coating machine equipment, must be placed in accordance with the button to be able to change the parameters;After stopping each class, you need to wash the hopper, scraper or coating roller and backing roller immediately with alcohol or acetone. The surface can not be scratched or damaged.Be careful to keep the back roller cylinder and linear slide clean and lubricated.

 

Next, the coating machine bearing parts should be regularly refueling lubrication, gear box need regular oil change or supplement.During the operation of the process once the problem is found to be recorded immediately, and pay attention to inform the relevant departments to facilitate our timely processing.We should always do a good job 5S equipment, equipment and the surrounding environment to maintain clean and tidy, so that we will facilitate the next work.

 

Coating equipment operating procedures, we must pay attention to set the coating mode of work and the relevant parameters (coating speed, length, gap length, roller speed ratio, etc.)Then turn on the compressed air (adjust the pneumatic control box regulator makes the pneumatic pressure maintained at between 0.2 ~ 0.3Mpa);After that, the coating machine equipment operation, pay attention to start drying fan and drying temperature controller.

http://www.xindoumachine.com/