Wearing route and feeding mechanism of hot air setting machine

- Apr 30, 2019-

The correct threading route of the hot air setting machine is put into the cloth part guide cloth 9 from the feeding frame to the operation table), and the guiding belt of the cloth part is worn along the correct cloth feeding route (from the cloth feeding super-feeding roller to the cloth feeding super-feeding roller) Out of the shelf). The red stop button on the lower operation panel stops the chain and the power-on indicator flashes. Put the guide cloth on the tenter chain and press the super-feed wheel down button for about 10 seconds. The button to be pressed is on.

 

The hot air setting machine opens the motor of each part of the feeding mechanism to "1". Raise the sump, apply the rolling pressure, open the motor of each part of the console (except the upper needle protection inlet button), and click the upper left corner of the feeding mechanism to enter the overall control button to green.

 

The hot air setting machine needs to start the front part of the machine. When the operation is carried out, the upper needle protection inlet button is opened after the upper needle protection inlet is opened, and the upper needle protection inlet button is opened to "1", and the machine is stopped when the cloth is discharged to the cloth feeding super-feeding roller. Connect the guide cloth to the guide tape of the cloth. Click the main control button of the cloth outlet to green, open the motor of the cloth part to “1” (except the cooling tube tension motor switch), restart the machine and introduce the guide cloth to the cloth rack and stop. Open the cooling cylinder tension motor switch to "1".


https://www.xindoumachine.com/