Safety procedures for coating machine

- Oct 16, 2019-

The requirements for the operation safety of the coating machine are specified to ensure the personal safety of the operator and the normal operation of the equipment. When finishing the coating machine table, check the power supply, whether the circuit switch is normal, do not allow the solvent to be stained, spill it on the dangerous source such as the electric box and the electric wire; when preparing the rubber cloth, pull the A-frame or the box car, follow the prescribed route. Do not squat straight.

 

When wearing the guide cloth, wear it as far as possible while the coating machineis stopped. If it is necessary to wear the cloth during the operation of the machine, the speed must be controlled within 10y/Min. Special care should be taken when wearing the cooling wheel guide cloth. The sleeves and clothes buttons should be buckled. When using the pump, pay special attention to the head and hands not to reach the pump ascending and descending areas to avoid injury during the ascent or descent. .

 

During the operation of the coating machine, if there is a pressure roller on the coating head, special care should be taken not to overspeed, so as to avoid sparks caused by excessive static electricity and cause fire. In the production process, if you use the A-frame to take up, you should pay special attention to the cloth that can't be placed at high speed. When you pull the cloth, you should be careful not to get caught in the cloth wheel; in the production process, Do not touch the cloth roller to avoid being bruised.

  

When producing a cloth with a large static electricity, water can be properly sprayed around the machine to reduce static electricity. Do not touch the place with static electricity to avoid electric shock. In the course of operation, always pay attention to whether the exhaust motor is running normally. The exhaust gas generated inside the machine is eliminated in time.


https://www.xindoumachine.com