Ø A set of machine using a state of good or bad depends on the level of maintenance work,according to the rules and operating of machinery,the nature of the machine,reasonable use of the machine could make the machine in a long life.therefore,puts forward the following requirements to the machine maintenance.
Ø Regular lubrication ,see the table below:
Lubrication part | Lubricant | Refueling cycle | Cleaning period |
Main drive gear box and overfeed drive gear box | Machine oilHJ-50 | run of 500hs change oil after change once a year | Yearly |
Chamber in stenter wire rod bearing | 7017-1#high Temp grease | Yearly | Yearly |
Circle fan and motor bearing | 7017-1#high Temp grease | Once every three month | Yearly |
Stenter chain bearing | Kluber or Dupont high Temp grease | Yearly | Yearly |
Other rolling bearings | Sodium lubrication grease ZN-2 | Yearly | Yearly |
BJ2 Cycloid pin gear planetary reducer | 2 | Yearly | Yearly |
CJY-modle cylindrical gear reducer box | L-CKC100~150 lubrication | Run of first change once a month after once every three month | Yearly |
Chain and wheel | Sodium lubrication grease ZN-2 | Yearly | Yearly |
Splined main shaft | Sodium lubrication grease ZN-2 | Yearly | Yearly |
Pneumatic tension joint bearing | Sodium lubrication grease ZN-2 | Yearly | Yearly |
Ø Machines every once in a while changing width of different species.so that can avoid the premature wear of the spline shaft.Regular inspection the travel switch weather effective and the damage to change in time.
Ø Regularly clean in chamber stenter wire rod,clean once a month.
Ø For oil heating model ,generally every half a year,remove the filter of heating pipeline,clean it and use again.
Ø Regularly clean the hot air circulation system,especially the spray pipe to clean once a month.
Ø Regularly clean the exhaust fan and pipes,check every 3-6months so as to avoid accidents or lower efficiency.
Ø Regularly clean needle plate once a week.
Ø Clean the oil dish below the pipe once a week
http://www.xindoumachine.com/