Common quality problems in post-processing of stenter machine

- Sep 25, 2019-

Stenter machine for textile products post-processing work is very important, however, in the use of the process, there are some more common problems.In order to solve this problem, the correct operation steps are suggested as follows:


A) The cloth of the stenter machine have scratched.

For that matter that should check whether there is such a problem before, if have that need to be agreed by the leader then can work. If not , you should check whether advance machine cloth to wipe to have burrs or roller pressure side wheel is too loose or too tight, the above reason that can cause stenter machine out of the cloth has a scratch, it must be adjusted machine then can begin to work.


B) Stenter machine out of the cloth with the shape of the moon out of the needle, Roll has dead crease mark.

In the same way, check if there are any problems before, if have that need to be agreed by the leader then can work. If not , need to check whether the machine feeding pin is normal, overfeeding too much easy to pin off, bad brim holder brush, the position of the edge holder wheel is too high, the pressure is not adjusted, the pin or pin plate is not neat, into the edge of the cloth, all of the above will cause the stenter machine pin off or roll that must be repaired before starting to work.


Key word: stenter machine.


https://www.xindoumachine.com/setting-machine/