Briefly introduce the appropriate combination of structure types in fabric stenters

- Mar 02, 2018 -

Fabric stenter is a textile printing and dyeing equipment, by heating and tension on both sides of the role of stretch fabric can be made quite flat, and make its latitudinal width of the same device as a uniform device. There are many types of fabric stenters, but in terms of their basic structure, there are no more than the following combinations.

 

The first of these is the guiding device in the fabric tentering machine: a device for smooth guiding of the fabric into the tentering machine, generally consisting of a plurality of guide rollers, suction cutter and a support with rollers; Drafting device:

There are two types of cloth and needle board, the general cotton, wool fabric will use needle plate, silk cloth will be used to fasten the cloth, so that we can apply tension on both sides of the stretch cloth surface.

 

Fabric tenter frame heating device: There are two kinds of open-type and drying room. General cotton cloth will be closed drying room, the use of silk is open, heated by steam and spray to wet. One of the ironing device: After passing through the needle plate or cloth drafting fabric, there will be a curved edge of the Ruffle curved phenomenon, after the middle with the steam drum ironing, the Ruffian will Elimination, while at a higher temperature, will stretch out the width of the relatively stable size, while ironing the fabric will be more flat and bright.

 

Falling device in the fabric stenter: The cloth after the tentering will pass through a series of guide rollers, the cloth into a roll or fall into cloth by S-shaped swing into the turnover car into the next process.

 

Finally, it refers to the fabric tenter static elimination device: the actual use of such devices will be discharged through the tip or positive and negative offset, this time will be the top of the cloth after ironing friction generated of the electrostatic conduction escape, so to prevent the accumulation of static electricity to facilitate the workers to operate at the same time, but also improve the processing efficiency of the equipment.

http://www.xindoumachine.com/